SFPP-AT-LP-XXXX-60D is a hot pluggable 3.3V small form-factor pluggable transceiver module. It is designed expressly for high-speed communication applications that require rates up to 11.1 Gb/s, and is compliant with SFF-8472 SFP+ MSA. The module data link can handle distances up to 60 km with a 9/125 µm single-mode fiber.
• Applicable for 10GBASE-BX networks
• Compliant with SFF-8472
• Compliant with SFF-8431
• RoHS compliant
Parameter | Symbol | Value | Notes |
Absolute Maximum Ratings | |||
Storage Temperature | Ts | ‑40 ~ 85°C | |
Relative Humidity | RH | 5 ~ 95% | |
Power Supply Voltage | VCC | ‑0.3 ~ 4V | |
Signal Input Voltage | Vcc – 0.3 ~ Vcc + 0.3 | ||
Recommended Operating Conditions | |||
Case Operating Temperature | Tcase | ‑5 ~ 70°C | Without air flow |
Power Supply Voltage | VCC | 3.14 ~ 3.47V, 3.3V typical | |
Power Supply Current | ICC | 450 mA maximum | |
Data Rate | BR | 10.3125 Gbps | |
Transmission Distance | TD | 60 km | |
Coupled Fiber | Single‑mode fiber | 9/125 µm SMF | |
Optical Characteristics | |||
Transmitter | |||
Average Launched Power | PO | 0 ~ 5 dBm | |
Average Launched Power(Laser Off) | Poff | ‑30 dBm maximum | Note (1) |
Center Wavelength Range | λC | 1260 ~ 1280 nm, 1270 nm typical | SFPP-AT-LP-2733-60D |
1320 ~ 1340 nm, 1330 nm typical | SFPP-AT-LP-3327-60D | ||
Side Mode Suppression Ratio | SMSR | 30 dB minimum | |
Spectrum Bandwidth (‑20 dB) | σ | 1 nm maximum | |
Extinction Ratio | ER | 3.5 dB minimum | Note (2) |
Output Eye Mask | Compliant with IEEE 802.3ae | Note (2) | |
Receiver | |||
Input Optical Wavelength | λIN | 1320 ~ 1340 nm, 1330 nm typical | SFPP-AT-LP-2733-60D |
1260 ~ 1280 nm, 1270 nm typical | SFPP-AT-LP-3327-60D | ||
Receiver Sensitivity | Psen | ‑20 dBm maximum | Note (3) |
Input Saturation Power (Overload) | PSAT | ‑6 dBm minimum | Note (3) |
LOS ‑Assert Power | PA | ‑35 dBm minimum | |
LOS ‑Deassert Power | PD | ‑21 dBm maximum | |
LOS ‑Hysteresis | PHys | 0.5 ~ 5 dB | |
Electrical Interface Characteristics | |||
Total power supply current | Icc | 450 mA maximum | |
Transmitter | |||
Differential Data Input Voltage | VDT | 180 ~ 700 mVp‑p | |
Differential line input Impedance | RIN | 85 ~ 115 Ω, 100 Ω typical | |
Transmitter Fault Output‑High | VFaultH | 2.4V ~ Vcc | |
Transmitter Fault Output‑Low | VFaultL | ‑0.3 ~ 0.8V | |
Transmitter Disable Voltage‑ High | VDisH | 2V ~ Vcc + 0.3 | |
Transmitter Disable Voltage‑ low | VDisL | ‑0.3 ~ +0.8V | |
Receiver | |||
Differential Data Output Voltage | VDR | 300 ~ 850 mVp‑p | |
Differential line Output Impedance | ROUT | 80 ~ 120 Ω, 100 Ω typical | |
Receiver LOS Pull up Resistor | RLOS | 4.7 ~ 10 kΩ | |
Data Output Rise/Fall time | tr/tf | 38 ps maximum | |
LOS Output Voltage‑High | VLOSH | 2V ~ Vcc | |
LOS Output Voltage‑Low | VLOSL | ‑0.3 ~ +0.4V |
Notes:
1. The optical power is launched into SMF
2. Measured with RPBS 2^31‑1 test pattern @10.3125 Gbs
3. Measured with RPBS 2^31‑1 test pattern @10.3125 Gbs BER=<10^‑12
10 Gb/s 1310nm SFP+ 40 km Transceiver
SFPP-ATLP-31-20 SFP+ Plug-in, 10Gbps, 20km, TX=1310/RX wide, on two single mode fibers, LC/PC Blue
SFPP-ATLP-31-10 SFP+ Plug-in, 10Gbps, 10km, TX=1310/RX wide, on two single mode fibers, LC/PC Blue
SFPP-ATLP-31-02 10Gb/s 1310nm SFP+ 2 km Transceiver
SFPP-ATLP-51-40 10 Gb/s 1550 nm SFP+ 40 km Transceiver
SFPP-ATLP-51-100 10 Gb/s 1550 nm SFP+ 100 km Transceiver
SFPP-ATLP-51-80 10 Gb/s 1550 nm SFP+ 80 km Transceiver
SFPP-ATLP-85-03 10 Gb/s 850nm Multi-Mode SFP+ Transceiver
SFPP-LP-T99R-80 10 Gb/s Tunable DWDM SFP+ 80 km Transceiver
SFPP-ATLP-DXX-80 10 Gb/s DWDM SFP+ 80 km Transceiver
SFPP-ATLP-DXX-40 SFP+ Plug-in, 10Gbps, 40km, TX=ITU Ch xx (17 to 61) /RX wide, on two single mode fibers, LC/PC Blue
SFPP-ATLP-CXX-80 SFP+ Plug-in, 10 Gbps, 80 km, TX = CWDM Ch xx (1470 nm to 1610 nm)/RX wide, on two single-mode fibers, LC/PC Blue.
SFPP-ATLP-CXX-40 SFP+ Plug-in, 10Gbps, 40km, TX=CWDM Ch xx (1270 nm to 1610 nm) /RX wide, on two single mode fibers, LC/PC Blue
SFPP-ATLP-CXX-10 SFP+ Plug-in, 10 Gbps, 10 km, TX=CWDM Ch xx (1270 nm to 1610 nm)/RX wide, on two single-mode fibers, LC/PC Blue
SFPP-AT-LP-XXXX-40 SFP+ Plug-in, 10Gbps, 40km, TX=1270/RX=1330 , on one single mode fibers, LC/PC Blue
SFPP-LP-XXXX-10 SFP+ Plug-in, 10Gbps, 10km, TX=1270/RX=1330 , on one single mode fibers, LC/PC Blue
XFP-AT-LP-31-20 10 Gb/s 20 km XFP Transceiver
XFP-AT-LP-31-10 10 Gb/s 10 km XFP Transceiver
XFP-AT-LP-51-40 10 Gb/s 40 km XFP Optical Transceiver
XFP-AT-LP-51-80 10 Gb/s 80 km XFP Optical Transceiver
XFP-ATLP-XXXX-60 10 Gb/s BIDI XFP 60 km Transceiver
SFPP-AT-CO-02 10GBASE-T SFP+ Copper RJ45 30m Transceiver
SFPP-ATLP-61-80 SFP+ Plug-in, 10Gbps, 80km, TX=1610/RX wide, on two single mode fibers, LC/PC Blue
SFPP-AT-CO-03 10GBASE-T SFP+ Copper RJ45 30m Transceiver
SFPP-16-LP-85-01 16 Gb/s 850 nm SFP+ 100 m Transceiver
SFPP-A8LP-85-015 8.5 Gb/s 850 nm Multi-Mode SFP+ Transceiver
SFPP-A6-LP-31-02 6.25 Gb/s Single-Mode SFP+ Transceiver
SFPP-A6-LP-85-03 6.25 Gb/s 850 nm Multi-Mode SFP+ Transceiver
Get in touch with our experts
Feedback